Thermoplastic Technology*********** Industry Breakthrough







Direct Heat "Rubberized" Crack & Joint Sealant



Professional Results...No Melters...No Pour-Pots


















The Contractor's "RITE" Choice








Technology Breakthrough...


instantly & cures quickly (traffic ready in less than 20 minutes). The self-leveling sealant goes inside the crack...not over the crack.. .less waste, no tracking or unsightly residue. The Multi-Use formula can be used on asphalt & concrete pavement.
Why HOT Direct HEAT Process?
In the past, most contractors have had no choice but to use cold-pour or caulking-type fillers. Cold applied products fill from the

bottom-up & do not permanently bond/seal to the crack sidewalls. CRACK•STIX are hot applied, using a direct heat process (patent pending). CRACK•STIX form a permanent bond to the sidewalls of the crack or joint & provides a (liquid rubber) 100% water-tight seal. This seal will remain flexible & intact through the winter & summer expansion/contraction cycles.
Permanent Pavement Repair


Now for the first time, Industry professionals can get contractor-type results in 3 easy steps using 3 tools. CRACK•STIX comes in 1/4, 1/2 & 3/4 inch sizes.
They are User Friendly & Ready-To-Use: no mixing, nothing to add, just uncoil, cut-to-length, pack & heat.
CRACK•STIX are flexible & can be stretched & shaped to custom fit the repair. The rubberized compound melts/liquefies














Multi Use Formula...Professional Results...





3 Easy Steps...

Clean it... Take a screwdriver & scratch out all debris from inside the crack, then take a whisk broom & sweep it clean.
Crack must be dry.
Pack it... uncoil & cut the appropriate size stix & shape/pack into crack with fingertip pressure. Using the screwdriver, press the stix into crack approximately 1/16” to 1/8” below actual pavement surface level. To achieve a neat overall appearance, do not overfill crack. The material seals In It.. .Not On It.
Melt it... take propane torch & light it. Adjust bright blue part of flame to 1” long. Holding the flame 1-1/2” from stix, move the flame from side to side in a slow & even motion, heating no more than one foot at a time (melt stick until liquid). Seal cures in 20 minutes & is ready for traffic.


Areas of Use...

• Cracks & joints asphalt concrete lots & walkways
• Garage concrete slab/asphalt driveway joint seam
Parking garage/decks ... minimize leaks
Water main Public utility asphalt repair joint seams
Recreation facilities - tennis, basketball, volleyball,
shuffleboard or any other recreational surface
Excellent for fence & net post footings
• Curb & gutter flow lines  •Touch-up repairs

Convenient Packaging

2 Gal. Pail/150 Lin. Ft./1/2" Round






PO Box 583132
Minneapolis, MN 55458-3132


Phone:  (612) 371-4446
Toll Free:  (800) 879-9729
Fax:  (612) 371-4577

Contact Us